#SKYSCAN ATOMIC CLOCK SCREEN DOESNT WORK INSTALL#
#SKYSCAN ATOMIC CLOCK SCREEN DOESNT WORK MANUAL#

POSITIONING THE ATOMIC CLOCK: There are two possible ways to mount the Atomic Clock:  use of the foldout table stands, or  wall mounting FOLDOUT TABLE STANDS The foldout table stand legs are located on the backside, at the lower corners, and on both sides of the battery cover. ALARM SETTING To enter into the alarm setting mode: 1.  If no keys are pressed for at least 15 seconds in setting mode, the Atomic Clock will automatically switch back to normal display mode.

#SKYSCAN ATOMIC CLOCK SCREEN DOESNT WORK MANUAL#

Now the minute digits will start flashing.ĮXIT THE MANUAL SETTING MODES  To return to the normal display mode from anywhere in manual setting mode simply press the SNOOZE key anytime. Set the desired hours by pressing the + key followed by pressing the SET key. The hour digits will start flashing on LCD1. Note: In 12 hours mode the time will be displayed with an additional “PM” for the time from 12:00 noon until 11:59. The clock will then work as a normal Quartz clock. MANUAL TIME SETTING In case the SkyScan Atomic Clock is not able to detect the WWVB-signal (disturbances, transmitting distance, etc.), the time can be manually set. After completion of the above described procedures in “Setting up” the manual setting modes can be entered by pressing the SET key. MANUAL SETTINGS Note: If the Atomic Clock has already successfully received the WWVB time signal and displays the correct time and date, then the Manual settings can be omitted. 1.ĪTOMIC CLOCK LCD SCREEN DESCRIPTIONS The Atomic Clock's LCD is divided into 2 sections and once the batteries are inserted, all the segments will light up briefly before displaying the information for time, date, indoor and outdoor temperatures. SETTING UP: Do not set the clock until the outdoor temperature is displayed. Insert the batteries, observing the correct polarity (see marking).

#SKYSCAN ATOMIC CLOCK SCREEN DOESNT WORK INSTALL#

To install and replace the batteries, please follow the steps below: 1. TO INSTALL AND REPLACE BATTERIES IN THE TEMPERATURE TRANSMITTER The transmitter uses 2 x AA,1.5V batteries. Operation of this product is simple and straightforward. Providing WWVB radio-controlled time, date, time zone, indoor and outdoor temperature display, this innovative clock is ideal for home or office use.

This may take up to 5 nights.SKYSCAN ATOMIC CLOCK WITH OUTDOOR WIRELESS TEMPERATURE MODEL 86722 Instruction Manual INTRODUCTION: Congratulations on purchasing this state-of-the-art Skyscan Atomic Clock as an example of superior design and engineering. The clock is synchronizing to the WWVB signal and once the radio signal is decoded, the hands will automatically adjust to the correct time. Do not attempt to reset the hands manually even though the time on the clock is incorrect. If the clock does not receive the radio signal in the first 10 minutes, the clock will start running from the 12:00 position and will continue to run.

Note: The hands will move to the 12:00 position and search for the radio signal. During the night, your clock will automatically set itself. Position the clock on an exterior wall that faces Ft. Insert 1 fresh AA, LR6 1.5 volt ALKALINE battery according to the polarity marked on the case.ĥ. Slide the switch to select a time zone.Ĥ. Press the Set button at least 20 times to clear all memory.ģ. Remove the battery from the clock for 15 minutes. The factory restart returns the atomic clock to an “out -of-the- box” state and often resolves an issue.ġ.

Skyscan atomic clock screen doesnt work